TAPAS
free on-line service for the astronomical community
What is TAPAS ?
TAPAS is a free on-line service for the astronomical community, allowing the user to access a simulated atmospheric transmission for the specific observing conditions (description available in Bertaux et al., 2014). It can be accessed through the AERIS data base makes use of:
- NEW !! : the 2020 version of spectroscopic HITRAN data base. Note that before Dec. 6th, 17:00 GMT 2023, and since 2017, it has always been the 2016 version of HITRAN, despite an erroneous statement on this page, only recently corrected for.
- the most realistic atmospheric profile (temperature T(z) and pressure p(z) ) that is available from ECMWF meteorological field adapted to the location and time of the observation, with the addition of an estimate from MSIS-E for altitudes higher than 1 hPa pressure level. The composite profiles (p,T, density) is produced by an AERIS product called Arletty.
For observations in the future, a climatological atmospheric profile is computed – the LBLRTM software for the calculation of the atmospheric transmission in the spherical geometry, including refraction –
The user receives an e-mail indicating an address where he can find the required atmospheric transmission product. Then, the user may divide his/her observed spectrum by the simulated transmission spectrum to get the spectrum of his/her target “out of atmosphere”. Reports from problems encountered by users, comments, critics, suggestions, appreciations from the users are very welcome, and could serve for an improvement of the TAPAS Services. They all should be addressed to “Cathy Boonne (IPSL)”. She will either answer directly or redirect to the relevant TAPAS team member.
What TAPAS can do for you ?
- Make use of the AERIS facility to interpolate within the ECMWF (European Centre for Medium-Range Weather Forecasts) pressure, temperature and constituent profile at the location of your observing site and within 6 hours from the date of your observations.
- Compute the atmospheric transmittance from the top of the atmosphere down to the observatory, based on the HITRAN (high-resolution transmission molecular absorption database) molecular database and the LBLTRM (Line-By-Line Radiative Transfer Model) radiative transfer code.
- Provide separate transmittances associated with H2O, O2, O3, CO2, CH4, N2O and Rayleigh scattering.
- Allow disentangling atmospheric features from other absorptions in your astronomical spectra.
Definition of spectral interval for the computation
Wavelength coverage: the spectral interval may be selected within the window from 300 to 3500 nm.
Wavelength sampling, resolution and PSF
The resolution is defined as λ/FWHM, where FWHM is the Full-width at half maximum of an instrumental shape assumes to be Gaussian. The sampling is defined by the sampling ratio, the number of points per FWHM.
Selection of atmospheric constituents:
The user may select the transmission computation within the following list:
Rayleigh extinction, O2, Ozone, H2O, CO2, CH4, N2O. In the future, NO2 and NO3 from a climatology established from GOMOS /ENVISAT measurements may also be available. The user may also select the option in which the transmissions are calculated separately for each constituent, for a better identification of observed lines. The total transmission is then the multiplication of all individual transmissions. It also may be useful to get the H2O transmission separately, because the quantity of H2O may be adjusted by a power law of the transmission, Tx(H2O), where X is the adjusting factor. Such a formula must be applied, in principle only with the highest possible resolution, and after that the user may convolute by the spectrometer ILSF spectral profile. However, for weak lines (say, less than 30% absorption at resolution 40,000), applying the formula Tx to the convoluted spectrum gives a reasonable approximation.
Input parameters are:
- RA DEC of the target, or the zenith angle of the target.
- location of the observer (including the altitude). A list of most important observatories (with location and altitude) are included in the TAPAS data base, easing the user request.
- Arletty p-T profile
- H2O and ozone profiles from ECMWF.
The atmospheric refraction, which bends the light path and increases slightly the atmospheric path is taken into account.
The TAPAS team:
- Jean-Loup Bertaux at LATMOS is the overall scientific manager of the project.
- Rosine Lallement at GEPI is the chief scientist for the astronomy.
- Stéphane Ferron at ACRI-ST has developed the computation of the transmission with LBLRTM
- Cathy Boonne at IPSL is managing the AERIS/ESPRI data center.
- Elliot Richard at IPSL has developed the user interface
In addition, Alain Hauchecorne (LATMOS) provides expertise in atmospheric physics. He developed the Arletty product within AERIS.
Laboratories and institutions involved:
GEPI, LATMOS, IPSL, ACRI-ST
GEPI is a Department of Observatoire de Paris-Meudon (France), involved in many instrumental projects (ground-based and space-based, GAIA/ESA,EUCLID/ESA), dealing with stellar Physics and galactic physics.
LATMOS is located on the campus of UVSQ (Université de Versailles Saint Quentin) and on the campus of Université Pierre et Marie Curie, Paris, France.
IPSL (Institut Pierre Simon Laplace) is a federation of 8 laboratories, which develop a common strategy in the field of Climate research. It manages a number of observation services, and the AERIS/ESPRI data center for the chemistry of the atmosphere.
ACRI-ST is an independent R&D company based in Sophia-Antipolis, France. Its team of engineers and researchers provides skills in applied maths, geophysics, mechanics, numerical modeling, for studies, expertise, training, and environmental information services.: 260 route du Pin Montard, BP 234 06904 Sophia-Antipolis Cedex, France Tel +33 (0)4 92 96 75 00; Fax +33 (0)4 92 96 71 17.
Any question about TAPAS should be addressed to Cathy Boonne (IPSL) (cbipsl@ipsl.jussieu.fr). She will either answer directly or redirect to the relevant TAPAS team member.
Acknowledgements
This work is being supported by CNES (Centre National des Etudes Spatiales) and CNRS (Centre National de la Recherche Scientifique).
TAPAS is a service maintained by AERIS/ESPRI data center. AERIS acknowledges for TAPAS the use of HITRAN data base and the LBLRTM radiative transfer code, the use of ECMWF data and the AERIS/ESPRI data center. We acknowledge useful discussions with Iouli Gordon and Larry Rothman. Finally we acknowledge Atmospheric and Environmental Research (AER) for LBLRTM’s service and support .